Ford Automobiles Forum banner

ELMConfig error

2K views 2 replies 3 participants last post by  The Artilleryman 
#1 ·
I've been trying to use ELMConfig 2.17 and when I try and read the BCM it says 'Correct response from ELM Timed. Received response to request "AT L0":'

Has anyone had that error and sorted it so I can change the setting for Power mirrors.
 
#3 ·
I've had this error message, found it was caused by a cheap knock off chip set, rather than a genuine ELM327.

Although I've never had that problem with the modified ELM327 from Wales (he sells under various names), chip set is good, but the one I had the mod was very poorly done.

I ended up using the good board with the very good wiring from a far east supplier.

You can spend a lot of time trying laptops, OS etc but it all comes down to a good chipset on a well engineered board.
 
  • Like
Reactions: malford
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top