Jump to content


TalkFord Gold Members Don't See Adverts! Subscribe Today To Hide This Advert!




News Feed (View All Updates)


Photo

Fitting EGR Blanking plate


This topic has been archived. This means that you cannot reply to this topic.
1 reply to this topic

#1 twhuk1978

twhuk1978

    Little Megger

  • Members
  • 21 posts

Posted 04 September 2009 - 06:49 PM

Bought one from graemewelch on Ebay and wondering if anyone knows of a wiki/tutorial on fitting?

2001 TDDi 2.0 Zetec - Blue



#2 Mik.M.

Mik.M.

    Big Megger

  • Members
  • 411 posts

Posted 04 September 2009 - 06:55 PM

On the EGR valve you will see the metal pipe that goes across the engine.Where this connects to the EGR is where you put the blanking plate. Don`t forget to put the thin metal gasket back too. Clean the EGR using carb cleaner and plenty of old rags,don`t forget to wear washing up gloves.There is an easy to follow guide in the Wiki listed as EGR Clean out. Couldn`t believe the difference it makes. Mik.
03 TDCi 115BHP 6 Speed Facelift Estate in Stardust Silver,run in with 156000 miles on it. 18 inch Focus ST Alloys painted Anthracite Silver,K&N Panel Filter.Genuine Ford mudflaps.Nightbreakers.Footwell Lights.Final Facelift crystal side repeaters.Limo tinted rear doors and rear windows. Graeme Welch EGR Blanking plate & DeCat pipe.Jag Flip key finally done.

Now with new DMF&Clutch and rear wheel bearings + 1 front bearing.M-Tec Drilled & Grooved Discs,Mintex Pads.Front Fogs added.Front Grille blacked.Lower front grille sprayed black.