News Feed (View All Updates)
raynkar has posted in cannot open caliper to remove off disc(urgent) in Suspension / Wheels / Brakes / Steering (Mk3 Mondeo).
Today, 03:34 PM
iwols has started cannot open caliper to remove off disc(urgent) in Suspension / Wheels / Brakes / Steering (Mk3 Mondeo).
Today, 02:33 PM
robadub has posted in Independent Ford Specialist Garage in Shropshire ? in General Car Talk.
Today, 01:47 PM
scott2007 has posted in Memory problems, convers+ and radio doing funny things in Electrical (Mk4 Mondeo).
Today, 12:39 PM
Brake light problem
Posted 25 February 2012 - 07:43 PM
I tested all the other connections and I was getting 12.5 through them but then I tested the high level break light in the same way and the first test indicated too high a load to measure and the second one melted the wires on the tester?
I'm guessing as I had to replace a switch that there might be a power problem in front of it? Should this much power be coming through to the bulb it looks very burned inside? I'm stummped and have an mot coming up! Please and thank you for any help in advance!
Posted 08 March 2012 - 02:22 PM
Posted 08 March 2012 - 06:54 PM
I replaced my break light switch as none of them were working which fixed the high level light and briefly the near side low level light.
My van is ex police and has had electrics removed. I have found a bare wire running outside the main conduit into the rear of the van which has clearly been put there recently I'll have a look but as for the break light switch,it wasn't that!
Posted 08 March 2012 - 06:56 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users