News Feed (View All Updates)
Mondy zetecs has posted in Focus Mk1 estate rear pasngr door stuck AND el. window dead in Electrical (Focus Mk1).
Today, 11:06 AM
dieseldude has posted in Focus Mk1 estate rear pasngr door stuck AND el. window dead in Electrical (Focus Mk1).
Today, 10:38 AM
Gargravarr has posted in 2001 1.25 Zetec-S stalling immediately after start in Ford Fiesta Mk4 / Mk5 Forum - (1995-2002).
Today, 09:36 AM
Mondy zetecs has posted in Mk2 front bearings same as Mk3? in Suspension / Wheels / Brakes / Steering (Mk1/Mk2 Mondeo).
Today, 09:30 AM
TDCi cutting out
Posted 03 July 2008 - 03:03 PM
Posted 03 July 2008 - 03:08 PM
Your symptoms are very common, and replacing the cam sensor normally does the trick.
Posted 03 July 2008 - 03:16 PM
Posted 03 July 2008 - 03:43 PM
Was cam sensor. Fixed yesterday and, fingers crossed, all fine.
Ford introduced a 12Amp revised version from the original 5Amp which apparently is the "big Cure"!
Mk3 Ghia X TDCI Estate - You can get a shed on top and a bath in the boot!
"If the road is open then so is the throttle"
Posted 03 July 2008 - 04:46 PM
I agree about the Mk 3 estate, its huge!
Posted 05 July 2008 - 02:28 PM
I took a look at the sensor myself and it dont look new to me !
Dont some dealers really **** you off :annoyed:
Posted 09 July 2008 - 08:26 PM
Posted 18 July 2008 - 07:29 PM
Is it worth changing the crank sensor and checking the EGR valve and where are they located please. :annoyed:
Posted 22 July 2008 - 05:03 PM
The car went back into the ford garage today due to the car cutting out on me on sunday, then it did it again sunday night.
I made a note of what happened every time to give the garage some clues.
Was put on diagnostics and they reckon that it's the ENGINE WIRING LOOM.
This seems plausable, so we are going to bite the bullet and have it changed,total cost around Â£380 but should get it back on the warranty.
Posted 23 July 2008 - 11:58 AM