Ford Automobiles Forum banner
cylinder
1-6 of 6 Results
  1. Transmission / Drivetrain (Mondeo Mk3)
    Hello guys, Hope everyone is doing okay during these times. I'm having an issue with my old TDDI Mondeo; actually 2 different issues but I think they are related to each other. Current mileage is 142.5k. More or less at 140k the clutch pedal stayed down when entering a roundabout at a little...
  2. Ford Fiesta Mk7 Forum - (2008-2017)
    Hi, Daughters mk7 fiesta was broken into last night,they drilled the cylinder on the passenger door to get access. I rang fords this morning and they ordered a new cylinder lock after taking the car reg ect. I did'nt realise that they came in kit form and had to be built up, after watching a...
  3. Mechanical (Focus Mk1)
    Hi folks, Got another problem with my car, mk1 zetec focus 1.6. The biting point is very high and have to rev a lot to get going or else it'll stall. I was wondering if I bought this it'll fix the problem. Also how does a flywheel come into this, would i need it or is that something different...
  4. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    So i'll try and keep it short (never works): I'm getting code: P0351/P0352, but only when drawing load in the form of the headlamps/lights. Possible ground issue? or coil pack? Context: I left the parking lights on while shopping, upon returning to the car, it wouldn't start and the battery...
  5. Mechanical (Focus Mk3)
    Hi all, I recently bought a second hand 2011 Ford Focus Titanium, 1.6 TDCI.(85,000 miles completed) I took it to a Ford Servicing garage where they applied a software update to the car computer system. After the update they did a complementary Diagnostic of the car and found the following two...
  6. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    What a sunday. Took my engine apart. fault on cyl 3. exessive oil burning, no compression etc. After removing the cylinder head this is what i saw. Piston 3 damaged, some 2.5cm part broke of the edge of the piston. Unfortunaly this part seems to have been inside the cylinder for quite a while...
1-6 of 6 Results
Top