Ford Automobiles Forum banner
manifold
1-13 of 13 Results
  1. Mechanical (Mk2 Focus)
    My car started developing a whistling noise all of a sudden, took it to the local garage as I could not find the cause of the noise, they said that the actuator on the turbo was loosing pressure, so I found one off eBay and got the car rebooked in last Monday, left the car at 08:30, had phone...
  2. Ford Ka Mk1 Forum (1996-2008)
    Hi Folks, New to this forum, need some opinions from the more DIY experienced than myself. Ive had a couple oh Ford Ka's over the past few years, and became rather fond of them, Ive got to know them quite well and done a fair few repairs on both endura and duratec, such as front rear shocks...
  3. Diesel Engines (Mondeo Mk3)
    Hello all :L Car: Mondeo MK3 2006 TDCI 2.0 bog standard. Been a long time since I have been able to do anything with the car and I managed to snap one of the little m4 0.7mm torx machine screws inside the turbo :dang: I have some tools for small accidents like this so hopefully can remove...
  4. Ford Galaxy Forum
    Hi Gang I've spent a load of time searching for a video or guide for removing the manifold and/or EGR on a 2.2 Q4BA engine. I've found plenty for the 2.0 but almost nothing for the 2.2 Does anyone have a link to the video or forum guide please? I've got a very badly clogged up EGR at the...
  5. Diesel Engines (Mondeo Mk3)
    Anyone removed the egr cooler from the manifold and blocked off the hole? I need to swap my turbo and of course means taking the manifold off as well so I was looking into removing the egr cooler, cooler to egr pipes and the egr itself and fitting the removal kit with the boost gauge fitting...
  6. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    Hear ye Hear ye Good day everyone. I bring news of a terribly annoying ailment from which my trusty mondeo now suffers. I removed the intake manifold flaps after watching this video ( ) and finding my engine produced the same noises when removing and replacing the vacuum pipe. I got scared...
  7. Ford Fiesta Mk1 / Mk2 / Mk3 Forum - (1976-1995)
    Hi all, I got this afternoon for the first time on my 1995 1.3 HCS-powerd Mk3 Fiesta unusual noise sounding like a leaky exhaust pipe, but coming from the engine bay. This directed me to the exhaust manifold and the gaskets between the engine head and the manifold, which look in a rather poor...
  8. Exhausts / Induction (Mk3 Mondeo)
    Hello, for several months I've been looking for better performance exhaust manifold for Mondeo 3.0 V6 engine. I saw one youtube video where was installed such in mondeo which had engine swap, 3.0 installed. Those manifolds looked pretty much better than I've got on my St200, made by Toyosports...
  9. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    Hi, I have a 2001 Mk3 Mondeo petrol that has done nearly 70k. It is in great nick but..... about a week ago I have noticed a rattling coming from the engine ONLY at idle and ONLY when the engine is hot (not mildly warm, but hot). The rattling is irregular and sounds kind of like you are shaking...
  10. V6 Petrol Engines (Mk1/Mk2 Mondeo)
    Hey guys, I asked on here a few days ago about my ticking ST200, here's a 30sec clip of the engine. I've researched a bit - possible HGF, possible manifold gasket? Any ideas dudes? I'm absolutely smitten with this old girl, I can't let her be like this! lol Here's the link:
  11. Exhausts / Induction (Mk1/Mk2 Mondeo)
    Hi all, I having some problems recently with front exhaust manifold, which is racebits one. It is leaking exhaust gases and become noisy.Thought it's a gasket, so changed it to aftermarket one, which didn't made any difference, so changed to ford genuine, again without any difference. Manifold...
  12. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    I've just had the oil seperator hose replaced the one behind the inlet manifold on my '01 1.8 duratec which has cured the slow failing revs problem i had but now when the engine is up to temp it stalls at junctions ,i only picked the car up last night ,it was done by Hendy mechanic friend but am...
  13. Exhausts / Induction (Mk1/Mk2 Mondeo)
    My St24 is running lumpy and I've been told my rear pre cat manifold is cracked how easy is this to remove or is it better to put it into a garage?
1-13 of 13 Results
Top