Hi everybody TDCI 2.0 from 2006, Engine won't start. Before cranking, FRP_DSD=250bar, FRP=8bar, thats ok, while cranking, frp runs up to about 650bar after 5sec, then FRP_DSD goes down to zero, 2 secs later cranking stops. Changed IMV from a running car, applied 12V to the old one, it clicks...

Hi, I have a Mondeo 2.0 TDCI 130 2007 euro 4, recently it has started cutting out with fault codes P2051 and P1211. I changed the filter (genuine delphi) but this made no difference. Opened the old filter which was completely clean with no metallic particles so fairly confident the pump is...

Hi. I'm not that new here but this is my first post as until now I've been reading a lot around here but still have some doubts. I have an 01/2003 2.0 TDCI Mondeo 130hp with 134k miles and I've been having P0251 issues but only when I'd try to move the car in 1st gear by releasing the clutch...

Hello everyone, This is my first post and it's quite uncomfortable it being a post about my car not performing. Tho, I'm hoping ,from all the advices I get, to construct a guide that might explain this particular car behaviour to other users. So without further ado... First, I want to note...

Hi im sure a many of you have come across this problem while driving im getting the dreaded glow plug light flashing then engine dies, turn key and it bump start again, engine idles lumpy aswell. Here is what ive done so far im posting all this as i hope i can help someone else who is having...

Hi hope someone can help me with some info on my mondeo 2.0 tdci 2003 graphite. It wont start in the morning without easy start, and cuts out all the time with flashing heater lamp, and there is a lot of black smoke when accelerating. I suspect that my injectors were not working properly so i...

Hi hope someone can help me with some info on my mondeo 2.0 tdci 2003 graphite. i suspected my injectors were not working properly so i bought a f super to see what info i could get, when i tried to access the injector codes it only came up with codes for pots 1 and 4 and no codes for 2 and 3...