Ford Automobiles Forum banner
pulley
1-10 of 10 Results
  1. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    Hello, does anyone know the part nr. for the big bolt that holds the harmonic balancer (and the chain gear)? It's for a 2002 (pre-cacelift) Duratec 2.0 I am unable to find that bolt in any service manual for the MK3. I found one for a 2005-2011 Focus with the 2.0 Duratec, but am not sure...
  2. Diesel Engines (Mondeo Mk3)
    Ey up Quick question regarding the alternator pulley mod.. My friend said that the nut on the alternator would be left hand thread but the new pully i bought appears to be right hand thread ... Im really confused now, does the original nut on the alternator pulley loosen counter clockwise or...
  3. Air-Con / Heating (Mk3 Mondeo)
    Here's a detailed video on removing, and replacing, the alternator on the petrol 1.8 and 2.0. Lots of instruction for the diesels but the web seemed to lack info on the Duratec so I hope this helps some folk... I did this to replace my pulley, which is the over-running (clutch) type (OAP) -...
  4. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    Pics or it didn't happen
  5. Electrical (Mk4 Mondeo)
    Hello to Ford fellows. I am a new one in the talkford and I have been registered for knowledge and inquiries sharing. I had been driving a Ford Focus 1,6 petrol 2001 - 2009 when I bought a Ford Mondeo Mk4 1.8 tdci (QYBA-92Kw/125hps) Dec 2008. In 2012 when car mileage was 50000 miles the Mondeo...
  6. Diesel Engines (Mondeo Mk3)
    Hi everyone, Would really appreciate your opinions on this one: Recently changed the lower crankshaft pulley, tensioner and idlers, aux belt and also had the alternator and it's bearings refurbed. Car came back from garage, sounding ok on start up and driving, but there was a squeal whenever...
  7. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    (A second attempt at getting some answers from this forum. Moderators: If you want you can delete the previous thread from yesterday: http://www.talkford.com/community/topic/244753-noise-from-a-pulley-or-auxiliary-belt/) Hi all! A couple of weeks ago I replaced the auxiliary belt, tensioner...
  8. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    Hi all! A couple of weeks ago I replaced the auxiliary belt, tensioner pulley, and idler pulley on a Mondeo MK3 1.8L (pre-facelift, 2003). Lately, I have noticed a persistent "tapping" sound produced somewhere in the aux. belt area. The sound is quite obvious when idling on low RPMs, and...
  9. 1.8L / 2.0L Duratec Petrol Engines (Mondeo Mk3)
    I'm planning to change the idler pulley, but the bolt seems to be a bit (1cm) longer than the available gap between the pulley and the bodywork. Is there any trick to change it aside from lowering the engine or cutting the bolt :) thanks
  10. Diesel Engines (Mondeo Mk3)
    My car used to consistently idle at 800 RPM and now has developed a wierd fault at idle. Hope someone can help! At the moment any one of three things happen when idling: Firstly, most of the time when the engine returns to idle, the car either goes straight back down to 800 RPM when the clutch...
1-10 of 10 Results
Top