Ford Automobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I am looking at getting a cheap runaround mk1 while my mk2 is poorly and the one I have my eye on needs a driveshaft fitting, how easy is it to fit or how much is it likely to cost at a garage please.
Any help will be greatfully received.
Ta
 

·
Registered
Joined
·
59 Posts
Depends which side d/shaft you need to change.

Passenger side is easy,bottom ball joint,driveshaft nut,link off/track rod end.

drivers you can split where the bearing carrier sits.

basically the same principle for removal as the passengers.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top