Ford Automobiles Forum banner
1 - 6 of 6 Posts

·
MEG Corporal
Joined
·
801 Posts
Discussion Starter · #1 ·
a few week ago i noticed this and as long as i can remember they were flush with each other underneath.
Is my gearbox going/sliding/ down?
 

·
MEG Captain
Joined
·
4,819 Posts
if the gearbox is not mounted to the engine correctly then you would have noticed by now i reckon :whistling:
 

·
MEG Corporal
Joined
·
801 Posts
Discussion Starter · #3 ·
i mention above that as long as i can remember they were flush. this is new positioning i believe wich most likely/isuspect/ leads to the permanent rumble and vibrating at idle i have i.e. clutch not centered. the edge at the bottom is just a few mm (~2-3mm). the gb has not been touched for 8 months.
 

·
MEG Captain
Joined
·
4,819 Posts
so something has dropped out , a dowl pin maybe , just a thought :whistling:
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top