Ford Automobiles Forum banner
1 - 10 of 10 Posts

·
IDS SERVICES AVAILABLE - DENSO SPECIALIST
Joined
·
3,444 Posts
Discussion Starter · #1 ·
I thinkn i read somewhere that this controls a 'Panic Alarm' feature on Mk3 Mondy or ST220 alone..

Cant get mine to work, i press it and shout HELP HELP thats about it.. Car wont do anything..

Does it need programming in?
 

·
Registered
Joined
·
92 Posts
I have the same problem with my 2004 zetec s. The fob works fine. Locks unlocks opens the boot and does all it should but no alarm panic feature. The alarm def works ok. I have the motion auto lock activated unless this has something to do with it?
 

·
Megger
Joined
·
146 Posts
Works on my 2003 facelift Zetec TDCi

Frightened the life out of me when I tested it!!

:}
 

·
Megger
Joined
·
146 Posts
Erm, how does the panic alarm feature work on my facelift Mondeo then??????

:confused:
 

·
Super Moderator
Joined
·
5,343 Posts
reeso said:
Erm, how does the panic alarm feature work on my facelift Mondeo then??????

:confused:
Depends on when your car was made. If it on a 03/53 plate it will one of the first's facelift models, so the spec might be different to the later models.

Facelift models didn't come out proper until on 53 plates.
 

·
MEG Commander
Joined
·
3,573 Posts
The prob is that it won't work on cars with the Cat1 alarm. The ST220 has been fitted with Cat1 from Day1, the regular cars have it from 2003.75MY (facelift).

So, if you have motion sensors in your interior light, you don't have the panic facility.

In my experience it was of little use other than for scaring cats!
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top