Ford Automobiles Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have managed to get hold of all the parts to do a disc conversion on my Mk1 hatch. However the secondary hand brake cables will need replacing, I have priced these up at ford about £45 the pair. The question is are the cables from a saloon going to fit. As far as I can tell the only Mk1's with disks were the 2.5 version. Or will a Mk2 hatch handbrake cables fit? Also how about the rear brake pipes? will these need to be changed as well?
 

·
Turbo Boost Me!
Joined
·
1,018 Posts
You need the V6 cables, Saloon and hatch are the same, and im sure mk1 and 2 cables are the same too, About £20 each from a car spares shop, You also need the V6 flexi's
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top