Ford Automobiles Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
12,423 Posts
Discussion Starter · #1 ·
Does anyone here know if the ST200 clutch is the same as the st24/si/ghia x v6 cluches outhere

i think mine is on its way out and will need to do the job asap..

Any advice would be greatfully recieved

thanks guys

lee
 

·
AKA The Twigg!
Joined
·
9,331 Posts
as far as i know same clutch as the st24 mate. V6 engine same diameter clutch etc.

Dan :L
 

·
Big Megger
Joined
·
331 Posts
Good Luck - Starter motor will either come off the dowels easily or maybe not,mine was badly corroded and took lots of WD40 and gentle fettling to get off,otherwise job was no worse than any other ford fwd clutch to do.
 

·
at Vanishing Point....
Joined
·
3,994 Posts
KETTERSUK said:
fantastic guys thank you, and its bloody expensive, guess who is going to be doing this next weekend lol
So now wouldn't be a good time to say that Ford fitted a new clutch into my ST for all of £200 then.....

:tongue:
 

·
Registered
Joined
·
12,423 Posts
Discussion Starter · #9 ·
Rhys said:
KETTERSUK said:
fantastic guys thank you, and its bloody expensive, guess who is going to be doing this next weekend lol
So now wouldn't be a good time to say that Ford fitted a new clutch into my ST for all of £200 then.....

:tongue:
ah noooo :nono: :nono: :flipoff: :flipoff: :flipoff:
 

·
AKA The Twigg!
Joined
·
9,331 Posts
Lee----------0
Clutches-----2

Dan :L
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top