Ford Automobiles Forum banner

ST220 speedo dials

735 Views 3 Replies 3 Participants Last post by  KAZUYADOG
Hi guys

I have just swapped my standard dials on my Zetec-S V6 for the speedo dials from a ST220 (the silver ones) but noticed I have DTC fault code E197 and 9318. Any ideas what it is and how its fixed?


1 - 4 of 4 Posts
As usual, see the wiki.

Looks like a side-effect of disconnecting the cluster. So long as the speedo works, they should clear themselves after a few restarts and all should be fine.
So it "should" sort itself out? Correct me if im wrong, but these speedos should show the correct speed, no calibration required?
Do you know what year car the dials came from.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.