I took out the crankshaft sensor today to clean it as it had a few small filings on it and cut out yesterday so when I was putting it back I managed to break the mounting away from the gear box, anyone know where I might be able to buy a replacement? Or another solution would be great. The car is driving fine since but I'm sure a sharp bump in the road and it'll pop out of place.
coconut
Joined
·
34,555 Posts
Remove the rubber cover as shown in the smaller picture above and see if you
can access the bolts to remove the bracket.
If you can access them, Be very careful not to drop anything inside the housing.
If not then it maybe a case of having to remove the box. How did you break it?
Any how not to warning for the rest of us?
can access the bolts to remove the bracket.
If you can access them, Be very careful not to drop anything inside the housing.
If not then it maybe a case of having to remove the box. How did you break it?
Any how not to warning for the rest of us?
Joined
·
34,555 Posts
I did wonder about that, Dremel or grinder on the housing, But you dont want all
that swarf in the box. So you need to be careful.
that swarf in the box. So you need to be careful.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
