Ford Automobiles Forum banner

Crankshaft sensor mounting problem

16K views 9 replies 5 participants last post by  peter scott  
#1 ·
I took out the crankshaft sensor today to clean it as it had a few small filings on it and cut out yesterday so when I was putting it back I managed to break the mounting away from the gear box, anyone know where I might be able to buy a replacement? Or another solution would be great. The car is driving fine since but I'm sure a sharp bump in the road and it'll pop out of place.
 
Discussion starter · #6 ·
The only advice I could give is do not over tighten the bolt that keeps it in place, it only needs a slight squeeze. I'll have a look at it tomorrow evening and report back if I can get it fixed into place. Anyone know the part number or where I might be able to get a replacement mount?